Online Scooter Assembly.
      If you have any worries or questions please feel free to ask.  We are here to help.  We want to make your Retrobike experience a pleasurable one. Email us at info@retrobikes.com for help and questions.

Page: [1] [2] [3] [Next]

Inspect Contents Under the Seat

Examine Contents and familiarize yourself with the manual.

Tool Set

Next Check to make sure that you have all of your tools.

Locate Front Panel

Now you will locate the front VIN Cover panel.  If you need to have your scooter state inspected, Please do not install this yet. Just put the small panel in a safe place till later.

VIN Location

Here is the VIN Location.  Please make sure that it matches the paperwork that came with your motorcycle.  This is located above the floorboard on the front of your bike. (just look down)

Install Panel

After you have inspected your VIN number to make sure that everything is okay, go ahead and snap in your cover plate.

Assemble Battery

Locate your 12V battery and remove it from its box for installation

  Disclaimer:
      Please Remember that it is the customers responsibility to check ALL bolts, nuts and screws for looseness before & after riding.  An excellent solution for assembly is Loctite brand thread locker.  Loctite is a liquid that is applied to bolt threads to prevent them from vibrating loose.  Loctite may be purchased at any hardware or automotive store.  We recommend Loctite #242 for all general hardware and Loctite #243 for areas that encounter grease, oil and other lubricants.  If you own a motorcycle you are going to want to own some Loctite!  The instructions below are meant to help guide you and are no substitution for reading the manual and practicing safe mechanical habits.  Please acknowledge that Retrobikes.com is not responsible for misassembly, misrepresentation, overlooked details and shall be held harmless and free from any liability for any advice and instruction provided.